Posted by BarnyardEngineering on July 16, 2019 at 04:58:56 from (173.186.244.246):
I have one of those "poor man's" bale wrappers that rolls the bale along the ground as it wraps the plastic on the bale.
The problem I'm having is the hydraulic motor is direct coupled to the arm and it is very difficult to control. It's the lowest RPM hydraulic motor money can buy and it's still capable of several hundred RPM. Getting a nice slow consistent rate out if it is very difficult. Either the motor stalls out or it gets to whipping like crazy.
Easiest way to resolve this without major modifications to the machine is with a reduction gearbox. Problem is finding a gearbox.
There are thousands upon thousands of gearboxes out there online, but I can't find what I am looking for. Ideally it will have a 1" keyed input, a 1" keyed output, and a reduction of 5:1 to 10:1.
My google-fu is failing me. Surplus Center has nothing that I can find that will begin to work.
I would appreciate any and all suggestions, either of a better search method, or a source of a gearbox.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
