Posted by showcrop on July 11, 2019 at 16:48:42 from (75.68.37.174):
In Reply to: Baler questions posted by Grandpa love on July 11, 2019 at 15:37:46:
A MF 12 was the first baler that I wrenched on as a kid. It was nearly new but it had a major problem. The farmer that I worked for worked on it for awhile then told me that he and his kids were going to go milk and see if I could fix it. There was a timing diagram silk screened on the cover and within an hour I had it tying again. The old MFs are much better than old JDs and NHs because of the knotter design. Far and away the most common problems with both JDs and NHs are the tucker fingers and the twine wipers. MFs have neither. The clutch shouldn't be a big deal. At worst it would need a disc or two. I am pretty sure that the type that is on that baler you tighten the nuts to loosen it. Which you should do before every season to test it. Then you back off the nuts and the springs put the correct pressure on the discs.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
