Posted by super99 on July 02, 2019 at 15:45:31 from (50.103.120.155):
The used Land Pride bat wing mower that I bought last year has a couple grease zerks on the wing hinge that are rusted down to just a nub sticking up. When I went to lower the wings to use it, one side didn't want to come down until I let the pressure off of the cylinder and then crawled onto it and pushed , then let pressure off again and push. After about 4 times of this, it finally went down. I need to drill the zerk out and replace it to try to grease it. I know that they make a tap for a blind hole, but can I drill it out with a regular drill bit or do I need a special bit of some kind to drill it out? Will it matter if the drill bit drills into the hinge pin a little bit when I drill it out? I'll try to add a picture from my phone. Thanks, Chris
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
