|
Tractor Talk Discussion Board |
Re: Re: Re: Cutting the Grass
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Schotte on November 05, 2001 at 19:40:39 from (216.51.101.205):
In Reply to: Re: Re: Cutting the Grass posted by Terry Nelson on November 04, 2001 at 17:13:48:
Hey Terry. Sorry for the delay in getting back to you. As I said before, it's been quite a few years since I've used this particular machine. However, it performs great, just like it always did. The brush-hog I've got is a 5' Hi-Co, but long gone is any documentation which would tell me what it's "designed" horsepower rating was, etc. I have quite a bit of underbrush to clear now that I'm back on the property, but so far I've only mown the grass and small trees. Can't say I've ever tried a sapling as big as 2". I've never broken a shear pin- probably because someone (who will remain nameless) put a grade 8 bolt in there back when the cutter was new. (just changed this out last week) I'm more afraid of using the 'hog to cut trees, because of the potential for flat tires. I've already had the back tire off 7 times (for tube-related problems, not punctures)- but I'm very leery of making a bunch of short, sharp sticks that could puncture a tire next time I drive through. Usually if the cutter hits something big, gets out of balance, or catches some fence wire- then the PTO clutch lever just pops out of the "engaged" position. I just stop, re-engage it and am off on my way again. I've never had any problems with this combo, and am a big fan of the Case SC tractors. Sorry I couldn't be more help to you with specifics. Regards, Mike Schotte
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|