Posted by Kntwfarms on April 30, 2019 at 14:45:03 from (107.77.194.140):
I was brush hogging with my 4630 today. I was coming down a very steep hill in 1st/low and the hill was too steep so the tractor took off and when I got yo the bottom the wheels were turning in reverse. Now I'm that if at first it doesn't go right try it again type of guy so i tried it again while braking slightly... same thing happened. Only once at thr bottom when i tried to shift, it wouldn't go in to gear. Actually when I clutched it kept going so i popped it out of gear. Turned the tractor off put it in first and drove up to drop off my bush hog. This time thr clutch disengaged the transmission but when i was done it wouldn't go back in gear. I turned the tractor off. Put it in gear and headed for the house. I decided to see if the clutch would disengage it again and it did. However this time i could shift in all gears, h/l, but when clutch pedal is released it doesn't engage the transmission. Fluid is full (just did a complete fluid change and put in the recommend fluid). Pedal is moving appropriately. What did i do? What do i check?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
