|
Tractor Talk Discussion Board |
Re: How is this possible? Hay production question.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe on October 31, 2001 at 16:44:43 from (65.44.207.90):
In Reply to: How is this possible? Hay production question. posted by 68 Mag on October 31, 2001 at 13:05:58:
I don't have an exact answer for your question but just a few comments. You would be surprised how much hay can be made from what appears to be so little ground or cover. I've seen half-knee high coastal bermuda make around a dozen bales on ten acres or so. If your thirty acres was high enough to need shredding, then it was probably high enough to make a dozen or maybe more medium round bales. I don't know what you have (bermuda, Johnson grass, native mix) so I can't be sure. You might not even have to sow this patch. Some folks simply fertilize and either aerate it or scratch it with a light disc or chisel. Again, this may depend on what you have growing there.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|