Posted by spider818 on April 11, 2019 at 20:07:09 from (174.207.1.116):
This message is a reply to an archived post by chief 83 on June 12, 2017 at 22:48:59. The original subject was "Re: NH 315 Baler Pickup Tines Not Turning".
I apologize if this is not allowed but I'm having the exact same issue as the original poster. Was in the process of baling and something went wrong and the flywheel shear bolt snapped. Replaced the flywheel shear bolt, got everything cleared out of the chamber and pickup, and can turn the flywheel by hand but the slip clutch that drives the pickup won't engage. It isn't that the slip clutch is slipping...whatever mechanism that is supposed to turn the drive side of the pickup drive slip clutch won't engage (note: can easily grab the chain that drives the pickup and turn it easily by hand). I found this post and noticed mention of a pickup slip clutch shear bolt but can't find anything like that in the parts diagrams.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
