|
Tractor Talk Discussion Board |
Re: JD 80 pup motor back fires through the carburetor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Duane(Pa) on October 23, 2001 at 18:18:56 from (63.27.159.74):
In Reply to: JD 80 pup motor back fires through the carburetor posted by Nate Lillibridge on October 23, 2001 at 17:41:09:
Timing IS adjustable. four screws to loosen in the vicinity of the point cam lobe (under dist cap) then you can change timing. sounds like you need to retard it. The book says to set TDC (mark on flywheel under a half moon shaped cover on pony transmission above big engine flywheel) then move Hot distributer til a spark appears on #1 plug(right above oil dipstick)then tighten screws This thing fires on every stroke at TDC seems kinda goofy. If you can get her to run, you might be able to set it by ear. ALWAYS motor the diesel on decompression before starting. What a beast!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Operator Safety - Loader & Backhoe Operation - by Staff. Loader Operation Do not transport anyone in the loader bucket. Always carry the loader bucket low for maximum stability and visibility, whether the bucket is loaded or empty. Always use the recommended amount of counterweihting to ensure good stability. Be careful when handling large objects such as round bales, logs,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|