Posted by Ken(Ark) on April 09, 2019 at 03:24:12 from (174.236.146.108):
In Reply to: Hurt at work question posted by philip d on April 08, 2019 at 18:55:12:
Even though I am covered by Workman's comp I would have a hard time filing a claim on something minor that I should have known better ( smacking my own hand with a hammer , nothing broken ) and will recover in time .
With that being said , I would have no problem filing a claim even on something small , because someone else wasn't paying attention .( smacking my hand with a hammer , dropping an object on my head , knocking me off a ladder , etc )
You wont really know how bad your teeth are until they completely heal , which could take months . You may find that they will never heal without help .
80% of employers will act like they care in the beginning but try to get out of anything that cost them money . I have seen it happen many times .Dr Jeckel and Mr Hyde and you thought all along that the owner was a pretty cool guy .
Document it . If the employer doesn't want to or hesitates , that is your first clue something is wrong . Employers know that if the injury gets better they can drop it and if it gets worse then they can help you .
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
