Posted by CGID on March 30, 2019 at 06:48:50 from (174.27.173.213):
In Reply to: free solo posted by grizz02 on March 29, 2019 at 21:20:04:
I watched it twice. I met the guy. Honnold was visiting relatives near here few months after the climb and he came to the climbing gym I go to for some exercise. He's a level-headed, meticulous planner. He is also in superb shape, unusually skilled and has the climbing experience to know when to say no. He had the decades long desire to climb El Cap, put in two years of focused planning and in the month prior to the climb he went over the route, while roped, around 15 times. He stashed water bottles and food where he knew he would need them. He essentially choreographed every single move on a 3,000 foot vertical climb. He has a strict training schedule. The climb occurred on a training day. He likened the morning's climb to "four hours of light exercise" and went for his regular training that afternoon.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.