Case, great idea, I have been designing and using solar power on my RV's for years !!!!!! Currently have 940 watts of solar, 50 Amp MPPT Solar Charge Controller, 520 Amp Hours of AGM battery storage, 2000/4000 Watt PSW Inverter, 4KW Generator...
A few things in the interest of Codes and safety and fire and battery protection are as follows:
1) When you run wiring FROM the batteries TO any devices (say solar charge controller or other loads or equipment) YOU MUST PROVIDE PROPER OVERCURRENT PROTECTION to protect the wiring and it needs to be located at or near the energy source IE the batteries NOT far away downstream...��.
2) In order to be able to shut off the solar panel from the solar charge controller I ALWAYS HAVE A SWITCHING DEVICE there at the solar charge controller. I use a manual reset DC circuit breaker there.
3) "Some" people place overcurrent protection right at the solar panels output but since that energy is somewhat self limiting and less of any risk or hazard, "some" do not THATS YOUR CHOICE
4) Size the wires for adequate ampacity and if voltage drop becomes an issue they might need re sized
In a nutshell I would have a shut off on the solar charge controller input and place proper overcurrent protection (fuse or breaker) where wires feed off the battery. NOTE an MPPT solar charge controller can yield more energy harvest then a PWM but they cost more
John T Retired Electrical Engineer and 49 year RV owner
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
