Tractor Talk Discussion Board |
Re: do it again
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on September 24, 2001 at 09:50:42 from (199.3.9.7):
In Reply to: do it again posted by bcPA on September 24, 2001 at 08:29:39:
With no particular model in mind, let's start a factory to make a reproduction. 1. Whoops, gotta put fenders & a roll bar on it, it's the law. 2. Gotta go 12 volt, no one wants 6 volt any more. 3. Gotta be 3-point, gotta have 1 hydraulics outlet, gotta have live pto & hyd, gotta have power steering. 4. A lot of people prefer diesel engines over gas, runs cheaper. Hard to buy a gas engine to drop in any more, and tooling up an engine plant will bankrupt all of us! Gotta buy a drop-in engine, and it will be diesel. 5. Folks can buy an old tractor for $1000-5000, repair it up themselves for another $1000. We would need to charge $10,000 for ours. So, what do we have? A bigger-end Japaneese compact tractor. Not many of the parts will really interchange with the old stuff. I really, really like your idea. I wish someone would. But it just isn't practical. Wish it was. JD & NH have started 'ecconomy' lines the past decade, to try to capture a bit of the market that doesn't need all the new dodads. That's about as much as we'll get I suppose. --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|