|
Tractor Talk Discussion Board |
Re: 6 Volt Generator Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on September 23, 2001 at 18:57:13 from (209.47.89.128):
In Reply to: 6 Volt Generator Question posted by KC on September 23, 2001 at 18:26:41:
I know a guy who said that he ran that line through some sort of a variable resistor that he hooked up. I think he used a variable switch of some sort from a fan motor (different speeds controlled by the switch). Don't know any more details on that part. Keep in mind that you have a 3rd brush generator there. There are a few good articles in the archives on those generators. The charge rate can be controlled at the generator itself (not immediately or conveniently of course) by moving the 3rd brush. The third brush is the one that is not fixed in place and is actually on some sort of an adjustable anchor plate. This gives you a basic control only - obviously it's not something that can be changed very easily.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|