We tried silage once but it wasn't right for our operation, trench silo long before bags came out.
Although it's true that most cows don't need any grain there are benefits to feeding them a little.
We have a small creep feeder on one farm for the calves, they will weight a little more than the calves from the other farm that doesn't have a creep feeder. Those calves are also much calmer and easier to work because they're used to being near you.
A few buckets of ground corn feed to the cows every once in a while keeps them accustomed to you and makes working them much easier. If I take a bucket of feed and call the cows they'll come running and I can lead them right into the working pen.
We do have an advantage in that we have a old no-til corn planter, corn picker, grinder-mixer and a place to store ear corn, all that have long been paid for. We only plant a few acres of corn for feed so the cost is minimal.
Animals just like us like a little change in the menu at times, our cows come running when I head to the bunk feeders with buckets in my hands.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
