|
Tractor Talk Discussion Board |
Re: Got whipped today
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JNolan on September 09, 2001 at 05:10:16 from (216.40.137.31):
In Reply to: Got whipped today posted by Shaw on September 08, 2001 at 18:26:23:
Back in the 60,s my family built our golf course with our old Jd A and a roll over scraper. We dug ponds and ditches tees and greens over the years. The neighbors tried pulling that scraper with their 901 or 960 ford. On the disk or drags it would leave that old A behind. Hook it up to that scraper and it couldn,t climb up on a green or pull the clay out of the ditches or pond. If someone was stuck don,t bother just get the JD. In 1970 I bought my first G with an 800 hitch and 3-14 plow. It would make his ford and his big tractor a 4000 diesel look so bad when plowing he went out and bought a new 2030 with 3-16 plow. Then we could stay together plowing without me passing him every 3 rounds. Hooked that G on the scraper and had to rebuild the bottom blade soon after as it looked like a half moon in about two hours.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
