Posted by Texasmark1 on February 08, 2019 at 16:10:15 from (172.242.9.56):
In Reply to: Ransomeware? posted by Bret4207 on February 08, 2019 at 06:40:42:
My Mac has an AP Cleaner AP and all you have to do is go to your Finder where all your Aps are located and look for the one that looks out of place.....mine had an olive drab square box (in 3 dimensions) with a white star on it. Grab it, pull it over to the Ap cleaner logo and turn it loose....bingo gone. Now my Ap cleaner icon in on my Dock at the bottom of the screen and it it happens again, the icon will also appear there and I'll do the drag and dump.
When they call back tell them there is nothing wrong with your computer.....then take it to a competent shop and be done with it.
I got mine on a site where a real distorted copy of Adobe Acrobat appeared and said I had to select the icon to install it to read the chart I wanted to read....should have known it was a hoax as to the poor copy of the box.....besides I later learned that Macs don't need or use Adobe....they have their own software internally that does that function for you.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
