Re: Head swap between flathead engines - A QUESTION ????

Posted by John Ne. on September 05, 2001 at 20:54:35 from (209.74.230.242):

In Reply to: Head swap between flathead engines - A QUESTION ???? posted by Amateur Mechanic on September 05, 2001 at 14:26:56:

This was used to check combustion area, after milling heads, line the combustion chamber valve area with modeling clay, lay the head on the block with gasket in place, no bolts, turn the engine over four times, lift the head and see if there is any valve contact. On this combination I'd definitely use two cylinder head gaskets. John in Ne.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Head swap between flathead engines - A QUESTION ???? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]