Posted by Blue_Tractor_Man on February 02, 2019 at 13:46:50 from (174.236.143.208):
Back working on my 1967 Kohler L600 flathead 4 cylinder engine. I bought it all new valves because the old exhaust valves were trashed and the old intake valves had rust and pitting. The book calls for the valve guides (cast iron) to be .312 - .313. One of the exhaust valve guides is on the upper edge of that, maybe .3135. The exhaust valve will have .005 clearance, and the book calls for .0025 - .004. So, it is about .001 - .0015 over spec. If it makes any difference, the engine has tappets that push directly up on the valve stem, so that there is no side loading whatsoever. It is an 1800 RPM engine, so it runs relatively slow. Also, since it is an exhaust valve, oil consumption and vacuum leaks won't be a problem. My guess is that in short order, soot will coat the inside of the guide and tighten it up a little. The guide is still available for $20 if the YT brain trust thinks I should replace it. I don't really want to replace that guide if I can avoid it. What do y'all think?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
