Tractor Talk Discussion Board |
Re: Using left-handed drill bits - A QUESTION ????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rhudson on September 03, 2001 at 11:46:24 from (63.124.154.5):
In Reply to: Using left-handed drill bits - A QUESTION ???? posted by Alberta Mike on September 03, 2001 at 07:26:20:
if the head is cast iron, and if you're pretty good (steady) with the welding rod and if it were me, i'd try it. 6011, 6013, weld through the nut (heavy nut if you can find one) let the heat soak to the head for about 60 seconds. dribble water on the nut only to cool it. good wrench, lots of your favorite pentrating oil and pressure on the wrench in both directions until you feel it move (hopefully) more oil and you're home free. if not you can always use the left hand drill. the easyouts....last ditch thing. if they fail you are in trouble.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|