Posted by K Effective on January 31, 2019 at 05:55:07 from (99.184.108.123):
In Reply to: No Heat posted by 2510Paul on January 31, 2019 at 04:13:40:
Ours quit making heat about 0500 today, At 0700 I checked it, was trying to start, but not. Went outside, and found a snow/ice plug in the inlet piping for the purge blower- looks like the drips of condensation from the purge exhaust is being blown by the winds over to the intake. Cleaned both side out, it fired while I was out there.
Fed cows and checked the waterer was open, and by the time IU came back in it was up to 59, on its way to 61 now.
When the drain line from the purge blower is plugged- it fills the fan with water and it can't spin up.
There should be a red LED on the control board, it will flash a code which may be listed on the side of the furnace or on the internet, it may tell you exactly that it is your flame sensor or lack of purge flow, or whatever.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
