So, just how did you determine that the HVAC tech was "licensed?" As far as I know, there is no more license required to be in business than a simple business license and insurance. How else do you think some of these scam outfits get into business?? While there may be some level of licensing to work on HVAC equipment, I would bet that not every tech sent out on a call is licensed or certified.
First, while it takes a lot of will power not to flame George (he posts what he had for breakfast and what color his boxers are some days), you are going to the other extreme.
I am all for testing for the presence of CO. I am all for having it done by a professional. I am also for PROVING that there is a problem BEFORE fleecing people out of their hard earned money. When working with gas, I would ALWAYS err on the side of caution. Getting too casual with gas can be fatal. BUT, seems to me that the HVAC guy was called because the furnace was NOT WORKING. Condemning a furnace without proper testing is a bit hasty. Apparently a "short answer" guy.
What George did may not have been the best course of action, I doubt that there was any issue of legality.
Lastly, I do believe that the gas company WILL check and test for CO as well as checking the operation of the furnace. I know that the gas company that I have will not only do testing, they also do furnace replacements. After all, as has been said, their business is to sell gas. you can't sell gas to a dead customer. They have a vested interest in keeping their customers alive.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
