Here is something i found: (If you can find the movement model number you may be able to get some more accurate instructions.) Clocks that require actual winding will have anywhere from one to three winding holes on the body of the clock, often in the back facing. Generally speaking, if the clock has a single hole, that hole controls the main time spring. If there are two holes, one is for the time spring and one is for the hourly chime. Some clocks also have a third hole, which governs the quarter-hour chime tones. Winding Up Your Wall and Mantel Clocks To wind up your wall or mantel clock, first locate the time spring hole. If you have more than one keyhole in your clock, this is usually the one located farthest to the right as you're looking at the clock's surface. However, models can vary, so you may need to experiment a bit with this.
Insert your winding key into the appropriate hole. You'll want to test with the key to find out whether to turn clockwise or counterclockwise. Whichever direction the key turns freely is the right one. If the key won't move easily in either direction, this indicates the clock doesn't need to be wound. Otherwise, turn the key until you meet resistance. Don't force the key further.
In clocks with more than one keyhole, the left-most hole usually controls the hourly chime, and in clocks with three keyholes, the center keyhole is typically for the quarter-hour chime, although again this can vary from model to model.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
