Posted by jeffcat on January 12, 2019 at 16:14:48 from (50.207.7.234):
In Reply to: An odd airplane posted by PJH on January 12, 2019 at 11:02:17:
Back in the early 80s the development work was being done by Boeing Vertal outside of Ridley park just south of Philadelphia. I serviced one of their big copy machines. I couldn't walk through the drafting room to the machine until they coverd up everything with sheets. They had a full size cabin mock up in the room. It was all made out of wood. From what I have read those had a couple of computer glitches and also some kind of air compression or unstable vortex stuff that would compound stability problems. They also were doing referb update work on the C-47 Shinook choppers. More like total rebuilds. Couple of smart @ss test pilots were out with a newly rebuilt chopper and TRIED to do and inside loop with one. They didn't have enough altitude and unded up doing ONE HALF of a loop right into the marshes on the Jersey side of the river. Complete 180 wheels up in the air. Kinda flat.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
