|
Tractor Talk Discussion Board |
Re: Common knowledge uncommonly hard to find
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on August 20, 2001 at 12:13:54 from (199.3.9.7):
In Reply to: Common knowledge uncommonly hard to find posted by Gil Huguley on August 20, 2001 at 10:34:15:
Dean did a good job. To exand a bit on the 3-point, there are many different catogories, well about 4 but 2 of those have different sizes. Cat zero is garden tractors, and often are not at all compatable with other cat zero stuff. Cat 1 is common for 20 to 60 hp tractors, cat 2 & 3 are on larger tractors, and I believe there might be a cat 4 on the huge tractors. Each is bigger & beefier to handle more hp & bigger lifting loads. What really messes us up is that some cat 2 equipment has a cat 3 width, and some cat 3 equipment has a cat 2 width. This makes it hard to use quick hitches. Your tractor is probably cat 1. Another way of looking at live pto & live hydraulics is that these options are always available to you, no matter what gear you are in, whether you have the clutch pushed in or not. I have a loader on my H tractor without live hydraulics. Every time I push in the clutch, the hydraulics stop working so the loader doesn't lift. Think about that - drive into a bucketful of dirt or manure, push in the clutch, and nothing. Shift to nuetral, raise the load, shift again, get to where you want to dump, if you need to raise the bucket a bit, ned to shift to nuetral... Etc. The wear adds up on your knees, and jobs like baling or snowblowing where you need to stop moving forward but need to keep the machine spinning behind you to clear out overloads becomes very tiring. --->Paul
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|