|
Tractor Talk Discussion Board |
Re: 1001 uses for a loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on August 16, 2001 at 20:57:56 from (128.242.4.59):
In Reply to: 1001 uses for a loader posted by D W on August 15, 2001 at 10:25:25:
I have used down pressure to drive steel posts. It is a 2 man operation becuase one has to walk along and stand the post up for the loader to come down on post. I have also put a chain on loader and rap chain around and round a post and taken them out but this is a 2 man operation as well to get a bunch of posts out in short time. I have also used loader for scaffling and shingled eve's of steep roofs off of them and delivered all material to roof with the loader as well. I have used manuer buckets with narrow teeth to pull small dead trees clear out of the ground enabeling me to pile them and leave no stumps. You just wedge trunk of tree between teeth and raise up and if it slips it will soon catch a limb and it will pull right out if root system is dead. Note I said small trees. There is no end to the use if you get handy with one. You just got to use your own judgement as for the safety becuase many jobs you will come up with may very well not be safe in regards to the manufacturer. The closest accident I had was one time I was pulling a post with a chain and had someone else running loader. After the steel post was pulled the operator lowered the loader. Before I could direct the post or move my foot the post came down right on top of my foot with loader on top of it. The operator just happened to see the loader on top of post and quit going down just in time. If he wouldn't have I suspect the post would of went right through my foot, shoe, and all. It all happened so fast and I am just lucky I wasn't hurt. Just remember safety first. I myself am sure I take to many chances with the above jobs so just remember to not overide the safety issue.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Bad Vibes - by Curtis Von Fange. One of the strangest ways to communicate with our tractor is to ask it how it feels. "Ask it how it feels," you say? Yup, ask it how it feels. Now, as with the other articles in this series one has to be able to hear what 'ole blue' is trying to say in response. The nice thing about our old iron friends is that they are usually quite consistent in their response, rather unlike some people I know who might change what they say due to the weather or other mitigating circumstances. But since t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|