|
Tractor Talk Discussion Board |
Re: Re: Farmall 856 vs JD 4020D
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Cliff Neubauer on August 14, 2001 at 10:16:15 from (208.145.207.60):
In Reply to: Re: Farmall 856 vs JD 4020D posted by JD70Jim on August 14, 2001 at 07:37:30:
I disagree with you about tractors this age not being primary tractors. We row crop 1400 acres and use 2 1066s, they are not our main field work tractor but I did drill 800 acres with one of them this spring, and last year all of our crops were planted with the two of them. Why would horsepower comparisons between the 856 and 4020 be unrealistic? They were both in the same power class at pretty much the same time. If they plan on pulling a chisel plow with the tractor then actual performance is important in their decision, not as important as a tractor getting used 500 hours a year but important none the less.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
