I just put up a 13' x 20' Shelter Logic building. Snow was already on the ground when it went up. Spread a tarp over the snow/ice and covered that with several layers of big cardboard boxes I'd been saving for a compost pile, but decided against all the chemicals in them, so now it's my floor. Also insulates from the cold ground.
We reached mid-30's today and sunny, so the building got right comfy inside. Was down to a T-shirt and flannel, and should have taken the flannel off. Sweated too much. Was probably close to 40F at shoulder height.
I'll be working.....ooops, forgive my language, using that nasty "W" word again! *lol* Anyway, I'll be doing 'stuff' out there when the temps are well below zero. If it's cold and also windy, I'll have a 4' x 6' room with 6' headroom and a small workbench for doing things; sharpening saw chains or anything I don't wanna do in the house. Setting up a makeshift sawmill in the rest of the building so I can cut some cants for an upcoming project.
Out there, with it dry, it's likely I won't be wearing gloves unless the temps inside the building are -10F or so.
It's all about what you're accustomed to. Most of you can handle 90F weather. Me? I suffer!! I turn on the A/C when outside temps hit 60F. I'd do it sooner than that if the wife would let me. :shock:
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
