Posted by redforlife on January 02, 2019 at 18:58:05 from (68.234.121.189):
I have a factory manufactured 2 wheel single round bale moving cart. I need to know who made it. It has one hydraulic cylinder mounted on top of the tongue. It is single axel two wheel pull type. It has a rounded frame that rotates backwards on the axel to back under bales. Has two arms that squeeze the side of the bale by way of cable and the hydraulic cylinder. It is factory made. NOT homemade. It is painted yellow. Atleast 25 plus years old. The only legable thing you can read on the decal is Henry. Does anyone know who the manufacturer was, and where they were located.
I seemed to have broken a part on it that is now missing from falling off when it broke. So trying to find out what the part looked like that I am now missing. Can make one if I just knew what it looked like. Just trying to find some pictures on the net if there are any to be found. Knowing the source of manufacturer sure would be nice!! Thanks in advance.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Diesel Vs. Gasoline - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I am in the market for an older tractor (to be read... cheap). I have been told a diesel holds up better than a gasoline engine as far a wear, tear, neglect and abuse. Since I am looking at older tractors that have probably been through it all, is it better to buy diesel? I do expect to have to do a good bit of work on
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
