There are lots of problems in the world that need solving.
The past couple decades, the far left does not seem interested in solving anything, just rally around for more taxes and one size fits all quick fixes that don’t really fix anything.
I’m just dumbfounded by it.
I realize the far left is going to be more artsy, feelings type of people and not understand science, but still and all shouldn’t the solutions we enact actually have some basis in helping the problems we face?
Placing buffer strips on ditches that have higher edges than the fields around them have negligible effect on the environment.
Wood chip pits gather nutrients in the short term if there are any nutrients to begin with, but over the long term they break down and release and create more solvable nutrients. I don’t see much value in that. Since many of us have moved on from open intakes to pattern tiling, less direct runoff is going in the ditches.
And so on.
It’s an ‘I feel good because I told other people to do sometying”’ Movement, and yet not very much is getting done. Mostly just raise taxes.
It makes me sad.
Yes there are plenty of things to complain about on any political side, but here we are talking about environmental regulations, and so here we need to look at those specifically. Minnesota for one is being regulated very poorly by down town Minneapolis politicians that don’t have a clue what is actually out in rural Minnesota, and it really hurts. And often is counter productive. But yet the city people cheer it one, oblivious to reality.
Apply some thought to it to fit what is being done? Would anyone dare?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
