|
Tractor Talk Discussion Board |
Re: Crank Starting
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carp on August 07, 2001 at 01:33:24 from (12.27.55.243):
In Reply to: Crank Starting posted by Josh Goicoechea on August 07, 2001 at 00:17:02:
I have a few tips. Only crank in 1/2 turns. Do not try to spin it all the way over. Pull up on the crank. Engage it on the bottom and pull up 1/2 turn. Be careful not to wrap your thumb around the crank like your holding a bat or a golf club. Keep your thumb on the same side as your fingers. Don't hold onto the crank any tighter than you have to. If the engine kicks back, you want it to pull out of your hand, not your sholder out of its socket. As far as throttle settings and choke, every tractor is different. My Farmall A for example starts like this. 3 cranks 1/3 throttle no choke. Normally starts 9 times out of 10. If not. 1 crank with choke and then crank without choke. Starts every time. One last piece of advice. If you have a JD, just buy a Farmall to pull it, it would be a lot easier.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|