Posted by VADAVE on December 21, 2018 at 11:56:46 from (68.100.99.27):
In Reply to: Question about calfs posted by larry@stinescorner on December 21, 2018 at 05:07:44:
All this controversy? When I was first trying my hand at farming, late '80's-early '90'- There was a n individual renting my grandfather's place to pasture a few head. I asked if I could run one with his herd and the answer was yes. He actually bought a calf/feeder for me at auction, pastured it all summer then in the fall called to say it was killing time. I went up brought the my truck to the pasture the man was there with some helpers they shot the about 900 lb. animal WITH A 22 then cut it's throat. After it bleed out he put in the truck and I drove to another farmer that skinned it pulled out the guts, saving whatever I wanted then rolled it into a cooler for a couple of weeks, I was called when the wrapping was done. Now where was this? The auction was either in Maryland, Virginia or Pennsylvania; The pasture was in Maryland and the cutter/wrapper in Pennsylvania. I know the butcher was inspected because he had a small business the rest were/are just local farmers. Does it make a difference that it was also in the Appalachian mountains. Could this happen today (20 year later) Sure.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
