Posted by Bret4207 on December 05, 2018 at 07:13:30 from (64.19.90.196):
In Reply to: Best new chainsaw? posted by modirt on December 02, 2018 at 07:26:11:
Quoting Removed, click Modern View to see
If you go to the following link you'll see the difference between chisel and chipper style teeth. When the cutting edge has a straight top plate with a 90 degree (+/-) corner, it's a chisel chain. When it has a mild radius on the corner it's called a semi-chisel and an arced/rounded corner is a chipper style. "Full" chisel is just to differentiate from "semi" chisel. "Full" can also refer to the difference between a "skip tooth" chain and a "full" chain, which regards the spacing between cutter teeth. Chisel chain comes with and without anti-kickback features, usually related to the depth gauge (raker) shape and size. By itself, I don't believe a sharp chisel chain is any more or less likely to kickback than a sharp semi chisel or chipper chain. But chisel is more aggressive in cutting so it's said to be more prone. I've had so called "safety chain" or anti-kickback chain kick back. Nothing bad happened to me because I have good safety habits when I use a saw as far as kick back goes. You keep your left arm pretty straight and don't lean over the saw and a lot less bad things will happen. Safety has to come first with any style of chain tooth. Myself, I've seen more people hurt with a dull anti-kickback type chain than with a sharp chisel chain, but that's just me and what I've seen. There is no such thing as a "safe" chainsaw chain.
The link shows just chisel and chipper chain. Semi-chisel just has a radius where the "point" on the chisel chain is.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
