Posted by OregonAaron on December 03, 2018 at 08:40:19 from (184.157.246.139):
So, I have a few ideas in my head already but I figured i would see if anyone around here had any genius thoughts. So, this year i bought 30 tons of hay- 1/2 in small bales and 1/2 in big rectangular bales. I wanted to try to ease my way into using big bales because the small bales are getting harder and harder to find and the cost is more. Anyhow, I have a ford 2000 with a loader, but only a bucket. I do not have forks or bale spears and I probably wont have them this winter. Worst case I will flake off the bales into a trailer, but it's time consuming. I just built a bale feeder out of some scrap metal and i would like to move a whole bale into it. Building some bale forks right now is not a good option with our recent snowfall. I figure I can pick them up with some lifting straps, but that's a pain too. So, does anyone have any ideas of a better way to move these? They approximately weight 1000-1200lbs and are currently single stacked 3 high in 1 row.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
