Posted by Determined on December 01, 2018 at 05:56:12 from (216.130.212.201):
In Reply to: Question about a Joe Dog posted by Bruce from Can. on November 30, 2018 at 18:09:24:
I have gone through the same dilemma and thought about doing what you are describing.
Which way to go depends on how far you are hauling your bales and how many you have to haul.
Self load self dump wagons are great for short hauls but if you need to to move the bales more than a few miles behind a tractor the time saved loading and unloading gets eaten up by the slow tractor speed.
Using an old trailer with a converter dolly like you describe will haul more bales at a time but then you need a tractor at each end for loading/unloading and another to pull it with.
Inline wagons behind a pick up work well for longer hauls, the self unloading ones make for a quick trip turnaround time.
Myself I use an old Louisville with an over sized rack on the deck. 2 rows of 4 on the bottom front to back like a tube and another row on top.
Real heavy silage bales I only take 8 at a time.
I only need 1 tractor in the field for loading.
Hauling 12 bales at a time and using the hoist it unloads a nice row in less than a minute.
On a 9 mile (each way) haul I average a load of 12 in 50 minutes.
Even with a tractor and wagon doing 10 mph a trip is going to take you an hour each way plus at least half an hour each to load/unload so probably 3 1/2 hours per trip.
In 3 1/2 hours I do 4 trips which means you would need to haul 48 bales in one trip with a wagon to move the same number a day as a truck can.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.