I have always started with a baking soda bath and scrub until no more green bubbles using a small stiff bristle plastic or brass brush (pull the 12v power feed fuse first).
Rinse with hot water thoroughly and apply lube/grease/spray of your choice. I have also had success sealing up the back side (where the wires enter) using Star-Brite liquid electrical tape from a can. (Before applying lube)
The cleaning process works wonders on battery terminals and cable clamps too. Usually cleans to nice shiny copper/tin/lead finish without causing additional damage.
I like the idea of the prefab and sealed connector from northern tool that Steve mentioned, but if you go that route I would recommend good quality heat shrinkable butt connectors crimped with the appropriate tool.
A good alternative would be soldering the wires and using adhesive lined heat shrink tubing over the connections.
A third option would be from a company called IPC (Innovative Products Company - bought off our local tool truck) makes excellent terminal cleaning/file kits but they start in the $30-$40 window.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
