Posted by Plant Doc on November 14, 2018 at 15:26:43 from (73.196.97.0):
Neighbor has a 6210 with a loader. Back in April his nephew changed the fuel filters and could not get tractor to start. He says he primed the pump according to the manual's directions. Tractor has not been toughed until yesterday when the owner asked me to get it started. I also tried to prime the injector pump but could not get fuel to come out of any injector line. It has an electric fuel pump and there is plenty of fuel coming out of the fuel filter breed and the fuel supply line where it enters the injector pump. I put on a new electric shut off solenoid and still no fuel to injectors. The system is supposed to be self breeding??? It is a little difficult to work on with the after market loader and I really do not want to take the pump off. Is there a screen or filter where the fuel supply line enters the injector pump? Is it possible something in the pump is stuck stopping the fuel flow? Need advice.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.