Posted by Jeff nwoh on November 09, 2018 at 19:51:20 from (98.30.191.15):
I posted a few days back about getting a bearing off its tapered adapter. The concensus was pretty much to cut it off and move on. I had to work the next couple nights, so I stewed on it a bit. I figured we'd give it another try, and if it didn't work we'd just cut it off.
I put the retaining nut back on flush with the end of the adapter, but not tight to the bearing. I then put the 3 jaw puller back on the outer race and torqued her down. Then we took the air hammer with a block of aluminum and hammered the adapter back opposite the direction the puller was pulling. It took a couple rounds, but it let loose. I don't think the bearing is any worse for the experience.
The tapered adapter on the fan was actually worse than the bearing. It required a fair amount of heat and persuasion with a sledgehammer and a block of steel.
I know everyone likes to know how stuff works out, so there you go. Thanks to everyone for their input as well.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Buying your first tractor: Choosing the right one - by Chris Pratt. They cost less than the tax on a new tractor (at least where we live). They have the weight to do the job. They are simple and understandable. They even have a history and can be restored to become a major source of pride and enjoyment. But how do you know what to buy and how do you make the right purchase? There is a surprising number of machines available in every shape and size imaginable. Like most things in life, your needs have a lot to do with wh
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
