Posted by jimg.allentown on November 09, 2018 at 16:28:17 from (108.16.40.107):
So as not to hijack the previous thread that was headed this way, I will start this one about junkyards.
Self service junkyards are relatively recent in this area. Most are secondary to the main full service yards. One yard has cars that are within 10 years old, and is a full service yard. You talk to the counterman, he takes your order, and you pick up your part once their crew takes it off. Once the cars in the yard start getting too old or too picked over, they go to the "back" yard. This is the self service yard. You pay admission to get in, bring your own tools, and take off your own parts. You also sign a waiver holding the operators harmless in the event of injury. Once you get the part(s) you need, you go to the checkout and the cashier prices your selection and you basically pay and leave.
Previous to this, the yards around were all full service. They only started going self service about 15 years ago. There are three outfits that I know of within 75 miles of here that are operating self service yards. I can only assume that they have checked out the legalities and liabilities of these operations before letting Billy Bob and Bubba loose in their yards. So far, after over 10 years of operations, there have been no major "mishaps" that have caused them to have to reconsider the whole self service thing.
One thing to note is that in the self service yards, the cars are older and get picked over quickly. There is still a high demand for used parts for older cars. Typically, cars last 20 years or more in this area in terms of being drivable and not completely rotted out.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
