Posted by 1946 BN IHC on November 06, 2018 at 15:14:45 from (45.58.247.142):
We recently bought a 1983 winidago class C BUILT on a 1983 Chev chassis with a 350 ,5.7 engine. We took two "short" trips with it. The engine is carberated, with a form of electronic ignition, cap and rotor with no points. The thought is to replace the 3 gear transmission with a 4,5, or 6 with overdrive. I was just talking with our mechanic; his comment was that there would be a lot of gear shifting as one drove along the highway. HERE ARE THE PARTICULRS FOR THE UNIT. TOTAL FULL POUNDAGE, 8000 STANDING POUNDAGE 3 TO 50000 ALUMINUM MAIN BODY SOME WHAT ARODYNAMIC WEDGE SHAPED FRONT. Present fuel milage about 11 mpg. Rear end 3:37 TIRES 950 X 16.5 SINGLE REAR.
QUESTION For those who know auto mechanics, power and transmition what would be our best or better choises? Wm.(email open)
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
