I bought a 90 acre farm back in 2007. It had 12 acres of scrub bush timber on it. I had the County Soil Conservation look at and tell what I can do with it. 8 acres I can do as I please. Clear it and farm it if wanted. The other 4 acres are a wetland ,which I knew. I asked if I could dig a pond in the wetlands. If up to them yes but- this land has flood easement through the Corp of Engineers for the Coralville Reservoir. Which I knew. They said I would have to get permission from the Corps.
So a year ago I contacted the Corps and they sent a guy out. He gets my name, address, and phone number and did not go to look at the site. Said I would here back from them. In Jan. 2018 I get a 18 page form in the mail to fill out. Mailed it back in March after getting all the info and GPS location of the pond site. Form said it could be 6 months to here from them.
I call in Sept as I had not heard from them. The guy I talked to said you have to go through our department before you go through theirs. So they sent me a 10 page form to fill out for them and 2 copies had to be sent to the DNR of the same form.
I get a email last week from the first dept. I sent the form to saying that I have to go through the other dept. first. Yep I know now. Then I get an email from the DNR saying the pond is ok with them but. I would need a permit from my county before building.
I also get an email from 2nd dept. asking if I knew the pond would be in a flowage easement area. Yes I know it is a wetland and is in an flowage easement area of the Goverments.
Anyway this is all to dig a 1/2 acre pond in a swamp. Sounds like they will let me dig but no final permission was given yet.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.