Is it just a corderoy surface or do you have holes and high spots. Corderoy tilt blade as far forward as you can and take as small a bite as you can. Now if holes and bumps a back blad will never smooth that out. If holes and the front end hits a hole it will raise the blade to go over a pile and next time it will be worse. Canyou somehow make an attachment on the back of plade that will stick out back about 4' and put a caster wheel on it. Ford years ago made a blade like that. I will get rid of the drop downs that keep getting deeper and with the blade riding onlt on the caster wheel with the lift letting it down as much as the caster wheel will it will smooth out the holes-dips and hills-high spots. The box blad works on the same principle being a lot longer the holes-high spots do not thro it off like the short back blade does. The tractor acts as on a piviot on the rear axle that makes the blade want to dig deeper where you don't want it to and not hit what you want to drag out. I have A 2N Dad bought new when I was 9 months old and am now 75. And I have graded many a mile of gravel drive. Mi gets so bad I have to use something to dig the dirt-gravel loose to the bottom of the pits before I can smooth it out.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
