Posted by MarkB_MI on October 05, 2018 at 03:42:35 from (174.230.1.228):
In Reply to: The SR-71 posted by Ultradog MN on October 05, 2018 at 01:15:34:
Back in 1981, one of the editors of Aviation Week magazine took a "test flight" in an SR-71. It's an interesting read and includes a lot of technical detail written from the perspective of an experienced and knowledgeable pilot.
Note: Because it's a scanned image, the PDF is a bit large, about 29 MB.
A few excerpts:
"As the aircraft rolled out, Thomas applied the brakes only to find that the pedals went to the floor..." "Until they have logged 60 hours in the aircraft, pilots are restricted to shallow bank angles." "When the inlet and exhaust systems are working properly, they produce about 90% of the SR-71's thrust at cruise speed." [meaning the turbines are only producing 10 percent!] "...it is possible to get lost quickly at Mach 3..." "If the [engine inlet] spikes are as little as one-half in. out of position for a given speed, fuel flow could increase significantly enough to necessitate aborting the mission." "At Mach 3, the SR-71 does not turn very quickly, and at a bank angle of 30 deg., our 180-deg. turn described a semicircle around Boise with a diameter of about 170 mi."
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
