The first one is a annual ryegrass grown mostly in the south in the winter. It is seeded in the fall to give green grass over the winter. Germinates real fast and cattle love it.
The second one is a perennial ryegrass that will come back every year. Mixed in with other grass seed sold in bags because it has fast germination. It is also a cool season grass that will die in the summer heat of the deep south.
The third one is not really a grass. This is rye grain much like wheat. It is a annual grown for its grain crop. One of its best benefits is weed control, which winter rye excels at due to that horticultural super power known as "allelopathy," i.e., the ability to inhibit the germination of the seeds of competing plants. This can work as a disadvantage if you use it as a cover crop and then try to plant other seed right behind it. In a cover crop situation if you time your cutting it will come back. If you cut it to early before it goes to seed it will regrow trying to produce a crop (its main objective in life) If you cut it late after it has gone to seed without harvesting the crop it will reseed itself.
It sounds like you have the third rye cereal grain growing and it has reseeded itself.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
