Posted by kcm.MN on September 25, 2018 at 16:58:58 from (174.219.17.169):
In Reply to: hay in woodstove posted by 88-1175 on September 25, 2018 at 16:07:45:
I doubt that those old bales will work well for you. If they've been stored outdoors, then some amount of the outer layers will be high in moisture, which will cause lots of thick smoke and steam, plus the steam actually having a cooling effect on your fire. You'll also have lots of ash, so lots more cleaning out the stove. And lots and lots of tiny sparks going up your chimney. You may have that already with wood, but will likely be worse using straw.
In order to make it work well in your current stove, you'd pretty much need to break down the 5' bales, then re-bale them into something more suitable for your stove (very tight mini-bales). If the hay goes in loose, it'll burn fast. If it's tightly bound, that "might" help, but hard to say. Those large bales somehow have a knack of wanting to stay tight even after the baling twine is gone.
rustyplow -- Same thing with your outdoor boiler. If you have small, tight bales to fit in your boiler, I'd say try it. But if you're cutting up larger bales and throwing the pieces or batts in, then it might well be more hassle than its worth. Your outdoor boiler would have an advantage over the indoor stove as there would be less soot buildup to worry about, due to the design of those units.
I just don't have a good feeling at all about using loose hay in a small indoor stove. Outdoor boiler....might be worth the experiment. Just, try it when there's no wind and with a garden hose handy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
