Posted by paul on September 21, 2018 at 06:42:56 from (174.219.19.15):
In Reply to: Hydraulic cylinders posted by Graveyard1984 on September 20, 2018 at 23:08:58:
What tractor you got, and are you welding up your own three point adaptor or are you buying one and just need to add cylinders to it?
There are so many options and answers to your question, it is hard to really help you.
Help us, by narrowing it down to where we can really answer you.
The fatter the cylinder the more it will lift, but slower.
An older tractor has less hyd pressure, and so will lift less. A worn old tractor has a leaky hyd pump and will lift even less.
Old tractors might only put out 1000psi hyd pressure, less if they are worn down.
A new tractor might put out 2400psi.
So........
Again, what tractor or what psi does it put out, and what weight of load are you wanting to lift, and how is the geometry of the 3pt hitch.... there are just too many variables to really help you yet.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
