Posted by Hay maker2 on September 19, 2018 at 09:03:58 from (24.39.246.162):
In Reply to: Tariff War Question ... posted by Crazy Horse on September 19, 2018 at 07:45:37:
Does anyone want to buy a $3000.00 American Made TV? Or do they want to buy the Wal-Mart option?
If they bring all this manufacturing back to America; do the American people want to work? In all of the factories I visit for service work most of them have a hard time finding some that is willing to work and be part of a team.
If they bring all this manufacturing back to America, the cost of these good will increase. Will you or I get an increase in pay to buy these goods? Or will the average middle class American fall further into the poverty lines?
Point is, we need options.
Whether it is China, another county in Southeast Asia or West Africa, there will always be cheap labor with low manufacturing cost and every little EPA on there ends.
With all of these tariffs, what has it done for the disgusting milk prices? And what about the other agriculture products? What have the tariffs done for them?
There was record high prices for dairy and grain under the last administration. Prior to that there was record lows for grain and dairy prices under the guy in the early 2000's. Are we repeating history at the pocket book of the American Farmers?
These are some go the questions I have and would like to hear answers too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
