Posted by GlenIdaho on September 15, 2018 at 15:09:11 from (65.129.158.154):
In Reply to: OT heat for garage room posted by rossow (mn) on September 15, 2018 at 10:28:39:
If it were me I would check out a direct vent wall furnace. I put one in my 24X24 shop and it does a great job. Our winters are fairly cold. During the winter I keep the temp at 55 when I'm not in the shop and boost it up to 65 when I am. My shop is fully insulated. I especially like it because all flames are enclosed and not exposed to anything in the shop. It draws from and vents to the outside. It runs on propane and is fairly economical to operate. I ordered it directly from Williams and installed in myself. Very simple to do. I trenched the ditch for the gas line and the LP company installed the tank and line. Your county will probably require a permit. Check the link below. Hope this helps.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
