Posted by Texasmark1 on September 14, 2018 at 05:47:16 from (67.54.129.99):
In Reply to: Water ballast as weight posted by valiant farmer on September 14, 2018 at 04:04:05:
Go to the Google search engine and google something like tractor tire filling adapter. Play around with the words as you have to hit the right word to trigger all the available responses that are stored in google.
Mine cost around US $10. The adapter fits either the standard Schrader valve or on tractor tires with the steel stem, the inner fitting (when you unscrew the Schrader), a larger in diameter reducing the fill time.
Rotate the tire till the valve stem is at the top. Jack the tractor so that it's weight is off the tire but the tire still rests on the ground....the way I do it. Let the air out and install the adapter or connect it to the hose and then the tire.
Connect a hose from your water hydrant, or if pumping a solution, from your solution transfer pump, or gravity if elevated storage above the tire, via a water hose and fitting to the adapter. Fill till the filling slows indicating that the fluid is compressing the air that was left in the tire.
Shut off the fluid source, open the air vent on the adapter and let the trapped air out. Close the air vent, open your liquid source and repeat the process till full.....defined as where you decide you want to stop filling.
It's best to use a container and pump so that you have a means of measuring your input. www has fill amounts vs tire sizes and recommended fill volumes as a percent of available inner tube volume.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
