Posted by DoubleO7 on September 02, 2018 at 08:32:44 from (104.136.210.65):
In Reply to: Ballancing a fan posted by John in La on September 01, 2018 at 14:40:20:
Ezee Pezee, Just take out the extra "L" in the word "ballancing" and I bet the vibration goes away. :lol:
Since the blades are bolted to the hub, mark where each is on the hub, and take them off.
Then stack them all on top of each other into one pile, if they do not nest together nicely, one or more need to be tweaked back into conformity.
One or more might have a twist or bend, etc. effecting pitch and creating the vibe. The leading and trailing edges might also not be the same, stacking them will show that too.
Make sure no blade holes are elongated and that when assembled the tips of the blades are all the same distance apart when mounted.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.