Posted by kcm.MN on September 01, 2018 at 20:13:43 from (174.219.8.90):
In Reply to: Ballancing a fan posted by John in La on September 01, 2018 at 14:40:20:
John, got some good info here. Growing up, Dad used the trial-and-error method on ceiling fans. He'd start with a cent and tape it on using masking tape, then turn the fan on low. If the fan wobbled worse, then try a different blade. First, as someone else mentioned, make sure all blades are clean and dry, and mounted tightly.
Once he tuned the coin on the correct blade, he'd then move the coin from side-to-side on the blade until finding the sweet spot. I remember one fan (el-cheapo with hardboard blades) took a quarter and another coin on one blade, plus another cent or dime or something on a blade next to it. Thought that was gonna drive him insane! *lol* After that, he only bought Hunter ceiling fans.
Another trick you can do initially is to get a fairly thin piece of cardboard about a foot long. Turn your fan on low. Then, carefully move the piece of cardboard to the face of the spinning blade and see if they all seem to be in alignment. Then do the same for the back face, and again for the ends. That will quickly tell you if the blades are at same pitch, length and plane. When doing this, make certain the piece is not able to catch on a blade edge. Doing so would result in a projectile.
Be careful. We don't wanna have to start calling you Stubby. *lol*
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
